All projects / Engineering

0 to 30 V variable power supply

PROJECT: 0 to 30 V variable power supply DRAWN BY: G. GELLA SHEET 6/14 SCALE 1:1 REV A
Focus
Power and machines, Design and testing
Main tools
Multisim, LM317T, SolidWorks
Headline result
Repeatability: +/-10 mV across 0 to 30 V

A low-noise linear bench power supply with a true 0 V output, designed and simulated in Multisim, with a SolidWorks casing and drawings.

Problem

A laboratory supply has to be precise, repeatable and quiet, and most simple LM317 designs cannot reach zero volts. The challenge was stable output at very low voltage and a clean output across the whole range.

What I built

Tools and standards

Result

The design meets the figures below in simulation and testing as recorded in the portfolio write-up.

Measured results
MetricValueSource
Repeatability+/-10 mV across 0 to 30 VAuthor's engineering portfolio (PDF)
Load regulation0.01 %Author's engineering portfolio (PDF)
Output noiseunder 1 mV RMSAuthor's engineering portfolio (PDF)

Visuals

Multisim schematic of the variable power supply: transformer, bridge rectifier, LM317H regulator, potentiometer, capacitors and an oscilloscope with probe readouts
Multisim schematic with live probes; the output probe reads 30.8 V.
SolidWorks isometric drawing of the power supply casing in steel, sheet A3, drawn by Gian Gella
SolidWorks drawing of the power supply casing (A3 sheet).

Sources